Builder looked at it and said he d have one of his siding guys come out and install flashing to fill the gap.
Gap between roof sheathing and fascia.
The correct placement of a roof drip edge is on top of the roof s exterior cover directly between the sheathing and the fascia board which forms a drainage gap between the drip edge and the fascia board.
Then i do a metal drip edge to cover it all.
On my shed my sheathing does not protrude actually how both my house and shed are done is a 1 x 6 house 1 x4 shed fascia is installed to end of rafters then 1 x 1 1 2 is tacked onto the fascia at the top.
Why is a drip edge important.
The staining on the fascia suggests that this bat problem has been going on for a while.
The roof sheathing comes down and ends on top of the 1 x fascia.
This is a pretty expensive home.
Re the fascia gap it is normally installed tight often the fascia is even installed up tight to the shingles so that the roof sheathing is butted to the inside of the fascia.
The worst part looks about 10 long but i can t see the whole roof since it is too high.
Cleaning gutters and notice 1 5 gap between roof deck and fascia board.
The gap between the roof sheathing and the fascia may be small but it was all the space that bats needed to get into the attic of this house in atlanta.
This material should have extended all the way to the bottom ends of the rafter joists where the roof deck meets the fascia board basically the area where the gutters are hung.
Unfortunately in most homes this is not the case.
Slowly move down the joint to apply a steady bead of caulk into.
I doubt that that is the root of the problem though.
I think that this practice differs by region though.
In most cases if the shingles go past the drip edge about 3 4 of an inch the shingle edge will break the surface tension unless your roof has a shallow pitch then the water will reach the drip edge and if drip edge is tight to the facia board it will run down the fascia so as added insurance leave space between the fascia and drip edge.