Garage Door Closes To Sensors And Reverses

The photo eyes send an infrared beam across the bottom of your garage door opening if that beam is broken the door will reverse.

Garage door closes to sensors and reverses.

Test the sensor eyes by connecting them to short wires directly at the motor unit. Photo eyes or safety sensors are mounted to the track on either side of the garage door about 6 inches up from the ground. Make sure the eye is aligned with the reflector at the opposite side or else the door won t close properly. The garage door opener has several safety sensors photo eyes in place to prevent damage or injury should something obstruct the door as it is closing.

If the door doesn t close and the lights don t blink replace the safety sensors. If the door closes and reverses it is traveling too far and you should decrease the travel. This is almost always the result of a dirty or obstructed safety feature. If the door reverses part way down and you are sure there is no obstruction or binding increase the closing force a small amount and try it again.

While holding the sensors close together and facing each othe click the remote. It goes partway down reverses direction and goes back up again. A garage door that keeps reversing when you attempt to close it with the opener might have a simple problem or a major issue that requires a service professional.