When the door is closed the cable sounds like a bass guitar string if you pluck it.
Garage door bottom roller popped out.
If you have a roll up door check the hinges that connect the panels together as well.
If you notice any more problems with jumping the track or misalignment repeat the steps above until the whole track is in proper alignment.
Reattach the automatic garage door opener.
Look for the point that it is closest to going back in.
Keep your leg aiming down parallel.
Instead if your setup.
Your door should be good as new.
Do you think some wd 40 might help and where specifically would i put it.
Keeping the new bottom roller out of the track lower the door to the next roller.
The first thing to do when a garage door has a wheel or roller that is popping off the track is to make sure the problem actually originates from the rollers and not from the door itself.
Raise the door partially by lifting it until one set of rollers aligns with the problem area on the garage door track.
Loose parts may also cause your garage door rollers to come off track so tighten any bolts and screws that appear loose.
One way is to find the point at which it angled out of the track.
This video shows an easy quick method for installing garage door rollers which doesn t require bending the track or removing hinges.
Ride the roller against the track as you open the door.
This most likely would be a point of imbalance door bottom not level as a result of worn tired springs or slipped adjustment of the springs.
Now lower the door again to the 3 rd replace it with the new one and this time push it back into the track.
In all seriousness garage doors are under a lot of tension my door has a cable that runs down the side of the door attached to the bottom roller with some red screws.
So do yourself and your loved ones a favor and never unscrew the bottom roller bracket.
It pops out while it s going around the curve and it only happens on the way up and yes it s an automatic door opener.
Open and close the door manually a few times to test if the rollers are operating smoothly.
A bent garage door section or a loose hinge can cause problems when opening or closing the door.
Secure the door in that location by clamping a pair of locking pliers on the.
